If you maintain the laser cutting machine like this, you won't have to worry about using it for another ten years!

Apr 08, 2025 Leave a message

 

Users of laser cutting machines know that the laser is a crucial component of the equipment-it's the core "power source" of the fiber laser cutting machine. The laser beam it generates allows for the rapid cutting of metal materials. Lasers are expensive and one of the costliest components in the system. Therefore, daily maintenance is essential to ensure optimal performance and longevity.

Today, we'll walk you through key knowledge on laser maintenance. Let's take a look!

 

[I] Daily Maintenance of the Laser in a Laser Cutting Machine

The laser should be checked and maintained before starting the machine each day.

Check the laser working gas and cutting gas. Inspect the laser working gas cylinder.

Check that the cooling water pressure is between 3.5 and 5 Bar.

Check the temperature of the cooling water. It should match the temperature required by the specific laser model.

Check the oil level in the laser vacuum pump. Refill if necessary.

Check for any leaks in the oil, water, and gas circuits of the laser. Also inspect the vacuum pump, resonant cavity pneumatic components, and pipe joints for leaks.

 

[II] Weekly Maintenance of the Laser in a Laser Cutting Machine

Check for the presence of oil or water in the laser gas mixing unit. If found, clean it promptly. Check the laser gas drying filter-if more than 1/4 of the color has turned red or white, replace it. The normal color is blue.

Check the oil levels of both the vacuum pump and the Roots pump. Refill if necessary.

Check the chiller filter for impurities.

Check the laser cooling water circuit for impurities.

Check the condensate level in the compressed air separator (located in the gas source unit). Also, check the vacuum pump oil level (located below the gas source unit). When the pump is cold, the oil level should be between +5mm and 0mm relative to the centerline of the oil window. Refill if needed.

 

[III] Semi-Annual Laser Maintenance (or after 2000 Hours of Operation)

Check for corrosion in the laser head cooling water pipeline. If corrosion is present, address or replace the affected parts promptly.

Check for oil leakage in the excitation power supply tank.

Inspect the high-voltage cable for damage.

Clean the interior of the laser resonator and all lenses, including the front window mirror, rear mirror, and reflectors.

After cleaning the internal lenses, the laser output mode must be readjusted to achieve the correct mode.

Replace the vacuum pump oil.

Replace the Roots pump oil.

Carefully tighten all screw plugs to ensure the airtightness of the Roots pump.

Clean the white plastic plug located on the gas exhaust side of the Roots pump outlet. Apply a thin layer of silicone grease to the inner surface of the plug. This grease helps absorb and capture physical impurities in the circulating laser gas. (Use only silicone-free high vacuum grease, and apply it sparingly.)

info-989-315