Solution to burrs when cutting with fiber laser cutting machine

1. Use auxiliary gas for cutting.
The purity of the gas must be high. It is best not to use cylinder gas, because after two fillings, the purity is not good and the gas is wasted. For example, when laser cutting stainless steel, it is recommended to use nitrogen as the auxiliary gas. Nitrogen is a flame-retardant gas. Nitrogen not only prevents the explosion point phenomenon in laser cutting during laser processing, but the heated end face will not be instantly oxidized, and the cut end face will be smoother and brighter. The auxiliary gas should be adjusted to a pressure of 12-15 kilograms. The nitrogen at this pressure will not completely prevent combustion, and can also quickly blow away waste and impurities to remove burrs.
2. Find a professional operator to debug the parameters of the metal laser cutting machine until they are normal, then you can successfully complete the cutting operation of the fiber laser cutting machine.
Some parameter setting factors of the laser cutting machine will also affect the appearance of slag, resulting in burrs on the fiber laser cutting machine, so the cutting parameters must be adjusted to the best. Equipment + gas + parameters are adjusted to the best, and the cut workpiece will be burr-free, making the cutting of the fiber laser cutting machine more high-quality.