Are there any installation tips for fiber laser cutting machines?

Fiber laser cutting machine installation tips are as follows:
1. Comply with the safety operating procedures of the fiber laser cutting machine. Start the laser strictly according to the laser start-up procedure.
2. Operators must undergo training, be familiar with the structure and performance of the equipment, and master relevant knowledge about the operating system.
3. Wear labor protection equipment in accordance with regulations, and must wear protective glasses that comply with regulations when near the laser beam.
4. Do not process a material before knowing whether it can be irradiated or heated by laser to avoid the potential danger of smoke and vapor.
5. When the equipment is started, the operator is not allowed to leave the post without authorization or leave it to someone else to take care of it. If it is really necessary to leave, the operator should stop the machine or cut off the power switch.
6. Keep the fire extinguisher within easy reach; turn off the laser or shutter when not processing; do not place paper, cloth or other flammable materials near the unprotected laser beam.
7. When an abnormality is discovered during processing, the machine should be stopped immediately and the fault should be eliminated or reported to the supervisor in a timely manner.
8. Keep the laser, machine bed, and surrounding areas clean, orderly, and free of oil stains, and workpieces, plates, and waste materials should be stacked according to regulations.
9. When using gas cylinders, avoid crushing the welding wires to avoid leakage accidents. The use and transportation of gas cylinders should comply with the gas cylinder supervision regulations. Do not expose the cylinder to the sun or near a heat source. When opening the bottle valve, the operator must stand on the side of the bottle mouth.
10. High voltage safety regulations must be followed during maintenance. Every 40 hours of operation or maintenance every week, every 1,000 hours of operation or maintenance every six months, must be carried out in accordance with regulations and procedures.
11. After starting up, you should manually start the machine tool in the X and Y directions at low speed, and check to see if there are any abnormalities.
12. After inputting the new workpiece program, it should be put into trial operation and its operation should be checked.
13. When working, pay attention to the operation of the machine tool to avoid accidents caused by the fiber laser cutting machine going out of the effective stroke range or the two machines colliding.