The operating steps of the laser cutting machine are as follows:
1. Preparation: Make sure the power supply and cooling system of the laser cutting machine are working properly, check whether the cutting head and optical fiber of the cutting machine are clean, and prepare the materials that need to be cut.
2. Set parameters: Set appropriate cutting parameters according to the type and thickness of material to be cut. These parameters include laser power, cutting speed, gas flow, etc.
3. Position the material: Place the material to be cut on the cutting table and fix it using clamps or magnetic suction to ensure the accurate position of the material.
4. Adjust the focal length: Adjust the focal length of the cutting head so that the laser beam can accurately focus on the material surface. This can usually be achieved by moving the cutting head or adjusting the lens.
5. Start cutting: Press the start button and the laser cutting machine starts working. The laser beam is emitted from the cutting head, focused by the lens, and irradiated on the surface of the material for cutting.
6. Monitor the cutting process: During the cutting process, you can monitor the cutting process by observing the positional relationship between the cutting head and the material, as well as the quality of the cutting lines. If necessary, the cutting parameters or focal length can be adjusted to optimize the cutting effect.
7. Complete cutting: When the cutting is completed, stop the laser cutting machine. Pay attention to safety and wait for the cutting head to cool before proceeding to the next step.
8. Cleaning work: Clean up the waste and debris generated by cutting, clean the cutting head and optical fiber, and ensure the normal use and maintenance of the equipment.
It should be noted that when operating a laser cutting machine, you must strictly abide by relevant safety operating procedures, wear personal protective equipment, and avoid direct exposure of the laser beam to your eyes or skin to avoid damage.
What Are The Correct Operating Steps For A Laser Cutting Machine?
May 18, 2024
Leave a message
