Reasons for burnt edges on metal laser cutting machine parts:
The metal laser cutting machine will generate a large amount of heat when processing sheet metal parts. The heat is not diffused in time, resulting in edge burning. When the metal laser cutting machine is processing small holes, the outside of the hole can be cooled, but the small hole inside the single hole has a small space for heat to diffuse, and the heat is too concentrated, causing overburning, slag hanging, etc. In addition, in thick plate cutting, the molten metal accumulated on the surface of the material and the accumulation of heat generated during perforation will cause turbulence in the auxiliary air flow and excessive heat input, resulting in overburning and edge burning.
Metal laser cutting machine cutting edge burning solution:
Solution to overburning when laser cutting carbon steel small holes: In carbon steel cutting using oxygen as the auxiliary gas, the key to solving the problem is how to suppress the generation of oxidation reaction heat. You can use the method of auxiliary oxygen when perforating and lagging to switch to auxiliary air or nitrogen for cutting. This method can process small holes with an upper limit of 1/6 thickness.
The pulse cutting conditions of low frequency and high peak output power have the characteristics of reducing heat output and can optimize cutting conditions. Setting the conditions to a single pulse laser beam, high peak output with high energy intensity, and low frequency conditions can reduce the accumulation of molten metal on the material surface during the perforation process and reduce heat output.
Solution for laser cutting of aluminum alloy and stainless steel: In the processing of such materials, the auxiliary gas used is nitrogen, which will not cause edge burning during cutting. However, due to the high temperature of the material inside the small hole, the hang-up on the inside will Slag phenomena will be more frequent.
The solution to this problem is to increase the pressure of the auxiliary gas and set the conditions to high peak output, low frequency pulse conditions. When air is used as the auxiliary gas, it is the same as when nitrogen is used. Overburning will not occur, but it is easy for slag to appear at the bottom. The conditions need to be set to high auxiliary gas pressure, high peak output, and low frequency pulse conditions.
